![]() ![]() Then the last phase is to take the bottom right tool and wash any dark parts of the plate clean by holding the stylus down on the plate until the dark cells are clean. Then swap to the tool in the middle right (tap the icon with your stylus) to equip the sandpaper, then scrub the white stuff in circles or short lines with your stylus to get the excess off and reveal the fixed plate underneath, as a warning, if you scrub too much after youve gotten the white stuff off, itll make a hole again, so be careful (listen for audio cues to tell when the white stuff has disappeared) ![]() If you see those holes, then use the tool at the top right to fill them in with the white stuff, thats the right idea If you see any blue crystal looking nodes, youll need to hold the stylus over them to drill them off, thatll be its own phase, and once theyre all gone itll go to the main phase that all plates have When restoring plates, there are 4 possible things to go through
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |